How to Install Exterior Plywood Siding
Plywood can be an affordable and appealing house siding. As it is wood, it can be finished with stain for a natural look or be painted any color. It installs than wood planks or shingles because it comes from panels. It is also possible to buy it for panels that can match walls high in various lengths. You can also choose from several surface finishes, from simple to feel resembling cedar. Like every wood, it be painted or resealed frequently and also has to be protected from moisture.
Nail metal flashing in the wall. Install exterior insulation or any rigid foam board over the basic home sheathing and wrap the home with a moisture barrier, typically a polystyrene sheet. Seal the backs of the panels and all edges with primer paint or wood sealer.
Use a level chalk line to snap around the home. Nail 2-by-2-inch ledger boards to the sill plates on the wall level on this lineup to support the panels; use 1/2- or 5/8-inch plywood to make a flush facet, with the plywood, foam board and sheathing. Make the ledgers adjust to the height of the panels, typically 9 ft on most exterior walls.
Place the initial panel in the back corner of the house that is quite visible from the road. Twist it with the ledger board along with the wall ; double-check with a level to make sure that it’s plumb and that the inside edge of the plank is at the middle of a wall chimney. Leave a gap of about 1/4 inch in the corner.
Fasten the panel with a hammer and galvanized finishing nails. Drive nails about 6 inches apart on the plank edges, about 12 inches in each single stud. Work in the corner into keep the plank side don’t nail both edges and then try to nail the centre. Place the minds of the nails if you plan to paint and fill out the holes; utilize in case you’re going to stain it nails that are colored to match the color of the wall.
Install panels onto the front of the wall, butting tiles together or using the tongue-and-groove overlapping that can be found at outside plywood suppliers. Check each panel with a level to be sure that it is plumb. Cut about windows, doors and other protrusions with a saw or jig saw. Quantify the cuts attentively, but leave openings of about 1/4 inch whatsoever edges to be covered by trim.
Cut panels work your way round the home to end from the road at the back corner least visible and lengthwise at corners. Install panels in the starting corner across the back of the home until you reach the corner with side panels.
Caulk all panel edges in the corners and in the roof intersection. Wood trim, typically boards, around all walls and windows in which the walls panels match the roof soffit and across the bottom to cover the ledger. Fasten cover plates over outlets, around other openings and dryer vents.