The way to Remove a Carpet's Transition Threshold
There are several types of carpet-to-floor transitions used to finish the edges of carpeting. Some types are concealed beneath the carpet while some are in plain view. Most carpet transitions mount to the ground using a fastener specific to the kind of existing subfloor. Identifying the kind of transition you have poses the biggest hurdle if you would like to eliminate it. Z-bars, metal clampdowns, flat metallic strips and tack strips are the most frequent sorts of carpet-to-floor transitions.
Remove a Z-bar by setting a flat pry bar below the edge of the carpeting and floor together the transition and gently applying pressure to appear on the carpet edge. The Z-bar is a metallic strip installed below a piece of tack strip. The edge of the carpet is secured under the edge along the strip. During setup, the carpet is tucked under the protruding edge and hammered down to secure it in place. Once the transition is loosened, use your hands to pull the edge of the carpet out and away from the Z-bar.
Remove a metallic clampdown using a small pry bar to propagate the clamp transition where it meets the carpeting. Teeth in the edge of the metallic transition bite to and hold the carpet in place. Once the transitions are set up, the carpet is cut accordingly and placed in the transition, which is then bent over to secure the edge of the carpeting. To eliminate this kind of carpet transition, then you have to first bend back the finished edge of this transition and eliminate the carpet to expose the fasteners. Remove any nails or screws that secure the clamp to the ground, using a screwdriver or hammer.
Remove flat metallic strips by removing the fasteners that secure the strip into the ground. The metallic strip works simply by covering the flux between the carpeting and ground and securing it with fasteners. You will need either a hammer or screwdriver to remove the fasteners. Removing them will release the metallic strip.
Remove tack strip transitions by pulling the edge of the carpet from the ground edge to expose the tack strip. Place a pry bar between the ground and the tack strip and tap with a hammer to eliminate. In rare cases, the tack strip is fastened to the ground with screws. In this case, you may need to pull the carpet back far enough from the tack strip to obtain access to the mounting screws. Remove the screws with a screwdriver to publish the strip.